SuperMotors SuperMotors SUPERMOTORS Search — try “orange Bronco on 35s”
1989 Ford Bronco “Eddie Bronco”
Home/ Registry/ Ford/ Bronco/ 1987–1991/ “Eddie Bronco” supermotors.net/registry/22698

“Eddie Bronco”1989 Ford Bronco

39 photos documented since 2010 1 years documented ♡ Follow this build

Photos

1989 Ford Bronco - First time towing. Fully stock Bronco. Stopped at a gas station before heading to the drag strip with The Silver Hornet (GTO). 1989 Ford Bronco - The poor guy rode like that even with a light load in the back. 1989 Ford Bronco - Air shocks solved this problem. 1989 Ford Bronco - First time topless and with new tires/shocks. 1989 Ford Bronco - First time topless and with new tires/shocks. 1989 Ford Bronco - Custom BMW halo lights. Matches The Silver Hornet (GTO) 1989 Ford Bronco - Also clear tails 1989 Ford Bronco - Newly painted cab roof. Was faded and rusty. 1989 Ford Bronco - Newly painted cab roof. Was faded and rusty. 1989 Ford Bronco - Painted FG top white to match cab roof. 1989 Ford Bronco - Pretty good for a rattle can job 1989 Ford Bronco - Still brown inside. 1989 Ford Bronco - Hurculiner DIY bedliner. 1989 Ford Bronco - Replaced body mounting bolt access covers with d-rings. 1989 Ford Bronco - Not for heavy strapping down. Only held in place by 2 #8 screws. 1989 Ford Bronco - Not too bad for a roll on. 1989 Ford Bronco - New headliner and visors installed. The white marks are where I was thinking of mounting an Explorer OHC. 1989 Ford Bronco - Newly reupholstered seats installed. 1989 Ford Bronco - Newly reupholstered seats installed. 1989 Ford Bronco - I wanted to retain a factory appearance but remove the majority of excess plasic in the cargo area. 1989 Ford Bronco - So I measured and cut the plasic panels and support straps behind it. I then bent the panels at a 90* angle with straight edges and a heat… 1989 Ford Bronco - Finished. Getiing ready to put the top back on..... 1989 Ford Bronco - Closeup of tailgate jam area. Went a little nuts with the bedliner. But that paint is tough when it dries! 1989 Ford Bronco - Closeup of driver's side aft panel contoured to fit bedside. 1989 Ford Bronco - Closeup of passenger's side aft panel contoured to fit bedside. 1989 Ford Bronco - Washed and waxed. 1989 Ford Bronco - Changed the weatherstriping and put the top back on. 1989 Ford Bronco - I can see my reflection in the paint! 1989 Ford Bronco - Tip I picked up from the boys on FSB! 1989 Ford Bronco - The distributor mounted ignnition module tends to overheat causing intermittent shutdown till it cools off 1989 Ford Bronco - The fix? Remove relocate and mount heatsinks/radiator fins to it and rewire. 1989 Ford Bronco - I opted to mount inside the airbox where the coolest air under the hood will be found. 1989 Ford Bronco - Being as how it is a 5.8 Liter it will be moving a lot of air over this guy. 1989 Ford Bronco - Just need some longer screws and to exend the wiring harness. 1989 Ford Bronco - Checking the fit beneath the filter. It's good!

The peanut gallery

No comments yet — be the first to add to the record.

Spotted in the wild

Seen this vehicle at a show or on the trail? Add your shot — the owner approves it onto the record.