SuperMotors SuperMotors SUPERMOTORS Search — try “orange Bronco on 35s”
Home/ Members/ muddybronco supermotors.net/users/muddybronco
MU

Member profile

muddybronco

77 photos 5 vehicles member since 2001 Maumelle, AR, U.S.A.

The garage · 5

muddybronco’s vehicles on the registry.

Latest photos

The newest 12 uploads from muddybronco’s garage.

1973 Ford Bronco - The test drive was awesome! This thing flies compared to when it had the 302 and C6. It even leaves rubber across peak… 1973 Ford Bronco - We were adjusting the shift linkage when a cloud of stinky smoke came out from under the hood. We feared the worst sinc… 1973 Ford Bronco - The finished product! It turned out fairly clean but it sure would've made sense to paint the engine bay before we drop… 1973 Ford Bronco - We had cut a section out of the throttle bracket at the bottom and weld it back together to clock the bracket down so t… 1973 Ford Bronco - Arial view of the PDB. These wires now have split loom protecting them. To the right of the PDB you can see C123 which… 1973 Ford Bronco - This still needs a little cleanup but it's just a busy area for wiring. C115 splits into 3 groups here: -The 7 factory… 1973 Ford Bronco - The Explorer starter solenoid coil grounds through its case so we removed the paint from the wheel housing underneath i… 1973 Ford Bronco - Since the Bronco doesn't have a true RUN/START circuit from the factory, we created one with a bridge rectifier and a r… 1973 Ford Bronco - Eight lonely fuses, two relays, and a diode are all that's left. 1973 Ford Bronco - OBD2 port (AKA DLC) for diagnostics. It has 3 wires from C115 and then a power and ground wire. Laying on the floor are… 1973 Ford Bronco - This is the alternator charge light and it does need to be a bulb rather than a LED, preferably with a 470 ohm resistor… 1973 Ford Bronco - Overdrive cancel switch and LED. There was a big hole here already so in it went. The LED has a faint glow even when no…

Clubs