Driven on 1 tank for a few years, then abandoned when the 2nd tank gave out. Given to another owner who planned to fix it, but abandoned it in the woods for a few years. Given to a 3rd owner who planned to fix it, but abandoned it in the woods for a few years. Sold to me. I drove it home before stripping it down for thorough repairs. Then Frank bought it while his '75 Bronco is getting some P&B repairs, and eventually, it will be his oldest son's first vehicle.
189EngMts.JPG 407 hits | 125.61 KB | Posted: 6/3/11 These were another part of the vibration during acceleration... It has been significantly reduced again, but there's still a little around 60MPH. I think it's the tires.
189EngMtRH.JPG 350 hits | 94.88 KB | Posted: 6/3/11 This is YET another part of the vibration during acceleration...
187EngMtLH.JPG 339 hits | 78.13 KB | Posted: 6/3/11 This is another part of the vibration during acceleration... I have the engine lifted & the nut removed from the bottom of the mount at this point.
186EngMtLH.JPG 333 hits | 87.79 KB | Posted: 6/3/11 This is another part of the vibration during acceleration...
185EngMtLH.JPG 372 hits | 86.98 KB | Posted: 6/3/11 This is another part of the vibration during acceleration...
165Rim.JPG 479 hits | 65.37 KB | Posted: 5/27/11 I finally found another chrome rim for the RHR.
164Rim.JPG 376 hits | 70.87 KB | Posted: 5/27/11 I finally found another chrome rim for the RHR.
36DashFixed.JPG 367 hits | 81.69 KB | Posted: 5/18/11 The dash clunked every time I hit a bump, so I tracked down & installed one of the few remaining repair kits.
45Hoist.JPG 741 hits | 66.17 KB | Posted: 2/21/11 To lift the bed for fuel tank access, I used my electric hoist (an ATV winch & some scrap metal).
. [url=http://...
76Solder.JPG 732 hits | 74.81 KB | Posted: 4/17/11 To temporarily run the truck on 1 tank, it was necessary to plug both front tank lines, so I used the old rear tank plate. I heated both tubes to dry the old gas out & cook the varnish into ash. Then I used a brass bore brush to clean the tubes ins...
49FrontTank.JPG 723 hits | 81.59 KB | Posted: 2/21/11 I'll vacuum & wash the tanks before opening anything.
02RHF.JPG 693 hits | 101.97 KB | Posted: 2/11/11 2 tires off the rims; 2 dead gas tanks; 2 bent bumpers; 2 missing window cranks; 2 undamaged pieces of sheet metal; a bent tie rod, and a shattered rear window.
00Junker.JPG 658 hits | 92.79 KB | Posted: 2/11/11 What a beauty!
47FrameRear.JPG 647 hits | 86.27 KB | Posted: 2/21/11 It'll be much easier to work on the tanks this way, rather than from below.
50FrameSide.JPG 639 hits | 103.85 KB | Posted: 2/21/11 Even though I put a safety strap under the suspended bed, I rolled the chassis out to work on the tanks.
10VECI.JPG 637 hits | 85.86 KB | Posted: 2/11/11 VECI Label under hood above master cylinder
For the label specific to YOUR vehicle, click [url=http://www.motorc...
[/ur...
